PDA

Teljes verzió megtekintése : kÉRDÉS



Tano
2006-09-19, 18:51
Segitséget szeretnék kérni.Van egy autoba való szabályzom,de semmit nem találtam róla.Lehet ,hogy valami sima alapszabi nem tudom.Az érdekelne milyen ,mekkora mocit lehet rákötni.A szabályzó egy DF-2-es Tamiyaban van .Elöre is köszönöm a segitséget. A szabira ez van irva. LM-406FB

pbalazs
2006-09-22, 21:23
Szia!

Ezt találtam róla, talán segít valamit:

Hobby Port LS ESC - model number LM-406FB

These are a good, cheap ESC as featured on the popular Tamiya-derived Bonzer / Cross Tiger monster truck.

It is compatible with Futaba and Acoms (and similar) radio systems. It features a single button setup - instructions supplied with ESC.

Manufacturer rates as a 19 turn limit. However, we have seen same ESC running 15 turn - it seems to depend on luck of the draw. Features thermal overload - it should cut out if you do put too powerful a motor on it. We would say stick to the makers suggestions though.




------------------------------
HOBBYPORT ESC SETUP

IT IS ONLY NECESSARY TO RUN THROUGH THIS SETUP IF THE ESC DOESN'T AUTO SET TO YOUR TRANSMITTER.

Power up and immediately hold down button for 2 seconds then release. The lights should then flash.

Pull the trigger or push your stick to the full speed forwards position. Whilst holding this position, press the button once quickly.

Then pull the trigger or push your stick to the full reverse position. Whilst holding this position, press the button again.

If the ESC seems to refuse to accept the setup, switch the "SERVO REVERSE" switch on your transmitter to the Reverse position and try again. The timing of the first push of the button is key to the setup - leave it too long after switching on and the ESC will not accept it, don't hold it long enough and it won't accept it either.
------------------------------

Balázs

Tano
2006-09-25, 11:01
Köszönöm a segitséget, erre voltam kiváncsi!